Q:Can I use this to make a hole in a PVC pipe end cap?
by|Jul 18, 2018
1 Answer
Answer This Question
A: Hi Rusty,
Thanks for visiting our site!
Yes, this will saw through a flat portion of PVC. Some melting could occur, so some deformation could be experienced due to heat buildup.
Thank you for asking,
-Travis
by|Apr 12, 2022
1 found this answer helpful
Q:I need to use a 1 3/8" hole saw (probably for a one time use) that will cut a hole for an air gap in the rear of a Kohler 18 Gauge Stainless Steel Vault sink, will this one work?
by|Jun 14, 2018
1 Answer
Answer This Question
A: Yes, provided it can go through the metal in the sink properly.
by|Oct 17, 2019
Q:Can this cut 1/8" - 1/4" thick acrylic sheet?
by|May 12, 2017
2 Answers
Answer This Question
A: Sure, If your acrylic sheet can be drilled without cracking using an ordinary drill bit.
Use a wood backing. Don't use a lot of pressure.