Questions and Answers for Arrow 3/8 in. Leg x 7/16 in. Crown Galvanized Steel Staples (1,000-Pack)

A:  No, they are compatible with JT21 and JT27 staple guns only. Mike

A:  Hello - The T18 uses T18 round crown staples. These JT21 staples will not work. - Your Arrow Fastener Team

A:  Hello - Your question was posted under the listing for 7/16" T50 staples so we need to know which staple gun you're inquiring about. Please repost your question under the listing for the staple gun and we can provide you with an answer. Thank you! - Your Arrow Fastener Team

A:  Yes

A:  It can easily go all the way down on plywood but i doubt it will do the same on stronger wood.

A:  Hey there, Arrow's T50 staples were designed to work with a variety of soft wood (pine, Douglas fir) and hard wood (plywood, MDF, oak), so it should penetrate most wood surfaces fine. However, we do always recommend choosing the shortest staple possible to achieve the required 3/16-inch to 1/4-inch penetration required for a secure hold. Using a staple longer than needed to achieve that may lead to the staple not firing flush to the surface, or possibly even staple jams. If you'd like more specific recommendations about staple size based on your project, feel free to give us a call at 800-776-2228 or to email customercare@arrowfastener.com. We're here to help! -Your Arrow Fastener team

A:  Yes, I used them to staple a bamboo privacy fence to a wooden frame on my carport.

A:  Definitely. Used on wood screen door.

A:  I'm not sure about it but i believe you are asking if it would get rusty incase it contact with water i believe this will rust it looks like just steel nothing special about it.

A:  Hey Andy, our regular T50 staples are steel wire and have an electro-galvanized coating. For most applications, these staples are fine. However, we do also offer corrosion-resistant stainless-steel T50 staples for outside applications, as well as rustproof Monel staples for marine applications. If you have any other questions about what staple is best for your project, feel free to reach out to us directly at customercare@arrowfastener.com or 800-776-2228. We're here to help! -Your Arrow Fastener team

A:  I don't know, but call Arrow. Good customer support.

A:  Hey Nick, these staples are not compatible in the Craftsman 68496 electric stapler, and Arrow does not currently have a 7/16-crown staple. We'd recommend reaching out to the manufacturer for assistance. Good luck! -Your Arrow Fastener team

A:  Best to stick with same brand on staples and stapler. But you can also call Arrow. They have good customer support.

A:  The dimensions are precise.

A:  Hello, Stephen. The dimensions listed are accurate. For the Craftsman electric tackers we know about, typically the T50 staples--not the JT21 staples--will work with the tool. If you email customercare@arrowfastener.com or call 800-776-2228 with the specific model number of your staple gun, we can double-check and verify that for you. Thanks for reaching out! -Your Arrow Fastener team

A:  1/4" 6mm

A:  Hi 126, sorry, these staples will not fit the Bostitch t5 stapler. You would need Arrow 586 staples or the Bostitch STCR5019 staples.

A:  yes the length is the important part, 3/8 should work. you can always refer to you tube by typing the stapler model # etc into the search

A:  It will work on Arrow JT21 or Stanley TR45 guns