Q:My problem is withAmerican Standard sink faucet Model 77645F pop up stopper. It will lift the stopper up, but when I pull the handle it will not go down, I have to push the stopper down with my hand. Do I need to replace the whole mechanism or adjust it?
by|Oct 29, 2020
1 Answer
Answer This Question
A: Kfisherwi,
You will probably need to replace the drain. . Please contact us directly through the American Standard website “Contact Us” located at the bottom of our home page and one of our reps will be able to assist you.
Sincerely, your American Standard Consumer Connection Team
by|Oct 30, 2020
Q:I can’t figure out how to remove the stopper to remove a clog. Any tips would be appreciated.
by|May 7, 2020
1 Answer
Answer This Question
A: Jen C,
To remove the stopper please follow these directions.
Disconnect the Cable from the Drain by unthreading the Cable
Connector Use fingers or small screwdriver under either side of
the Cam Cap to pry it out from the Drain.
• Remove the Cam by pulling it straight out while wiggling gently
to loosen the Rubber Seal.
• The Stopper can now be removed by lifting it out of the Drain.
Sincerely, your American Standard Consumer Connection Team
by|May 9, 2020
Q:My problem is withAmerican Standard sink faucet Model 77645F pop up stopper. It will lift the stopper up, but when I pull the handle it will not go down, I have to push the stopper down with my hand. Do I need to replace the whole mechanism or adjust it?
by|Feb 19, 2019
1 Answer
Answer This Question
A: We would recommend to try to adjust it. I have emailed instructions to you on how to do so.
by|Oct 29, 2020
Q:how do I fix leaky Marquette faucet
by|Nov 27, 2018
1 Answer
Answer This Question
A: Handy, Please contact us directly through the American Standard website "Contact Us" located at the bottom of our home page so we can assist you. Sincerely, American Standard Tech Team
by|Nov 27, 2018
Q:The current stainless steel faucet connector on my sink uses 3/8 inch compression thread and 1/2 inch I.P. pipe thread. Will this faucet connector work on the AMERICAN STANDARD Marquette? I will probably replace the hose but I want to make sure I purchase one with the correct fittings
by|Feb 11, 2018
5 Answers
Answer This Question
A: My husband thinks so if you replace hose but not sure. Put a shut off valve and by a flex line that fits the for inside pipe and buy hose that fits faucet and pipe
by|May 5, 2023
A: This should work, however, you may have to purchase a thread adapter. All this will do is convert the size of the threaded part between the faucet and your water lines.
by|May 5, 2023
A: Yes it's 1/2" on the faucet side. So your hose will work. I also had the 3/8 compression on my valve. BTW I had to use thin metal nuts on the faucet since my granite top was too thick. Not enough to threat hose onto it if I had used the thick plastic washers that came with. I had old faucets I took the steel plain nuts off of. Great solid feeling faucet by the way you will be happy with purchase.
by|May 5, 2023
A: The connection to the faucet is 3/8".
by|May 5, 2023
A: I am not sure if this is the correct faucet you are referencing. This is for the 7764 model.
Centerset lavatory faucet on 4" centers. 1/4 turn washerless ceramic
disc valve cartridges. Durable cast brass waterways with one-half
inch male inlet shanks. Metal body. Metal lever handles. 20" (500mm)
long flexible stainless steel drain cable is pre-assembled to faucet body.
Speed Connect® pre-assembled drain body with 1-1/4 inch (32mm) tail
piece. 1.5gpm/5.7L/min. maximum flow rate.
by|May 5, 2023
Q:How do I adjust height for drain stopper to allow water to drain?
by|Nov 10, 2017
2 Answers
Answer This Question
A: In the installation instructions for the faucet there is a section on how to adjust the cam assembly on the drain.
by|May 5, 2023
A: If the faucet is installed correctly. simply push the lever on the faucet down to lift the pop-up drain stopper.
by|May 5, 2023
Q:Does this fauret come with a plug and if not what should I buy?
by|Jun 15, 2017
2 Answers
Answer This Question
A: This product has a plug with the quick connect feature
by|May 5, 2023
A: If you are referring to the drain stopper, then yes, the drain is provided with the faucet.
by|May 4, 2023
Q:We have this faucet and after three years, the plastic(?) coating over the bronze is flaking off. The warranty doesn't seem to cover this issue.
by|Feb 4, 2016
2 Answers
Answer This Question
A: Please contact the manufacturer for assistance.
by|May 3, 2023
A: Just purchased so no problems yet. I do suspect down the road the finish will wear some because it is basically just painted on.