We've updated your selection

    STYRO Industries   FP Ultra Lite 2 in. x 2 ft. x 4 ft. Natural Tan Foundation Panel

    Set your store for local inventory & pick up options.
    • Description
      Model
      SFL-200-2102
      Internet/Catalog:
      203929088

      FP Ultra Lite Foundation Insulation Panels Tough yet light weight, prefabricated polystyrene insulation panels are pre-coated with an attractive pebble embedded in a polymer modified cementations coating which is bonded to the polystyrene insulation. These panels provide years and years of performance and durability and big savings in energy loss. Constructed of 2 in. thick rigid foam insulation, the panels will insulate, protect and dress up any exposed foundation. Designed with speed and efficiency in mind these panels are easily cut with a utility knife and adhered with our all-weather adhesives. Insulate and beautify your home with energy efficient FP Ultra Lite Rigid Foam Foundation Insulation Panels. These durable foundation insulation panels will insulate your home and cover that unattractive exposed foundation with a durable and attractive, richly textured finish.

      • Save money reduce foundation energy loss up to 22%
      • Beautifies your home or building with an attractive finished panel, increasing curb appeal
      • Panels are easily installed, either adhered or mechanically fastened
      • Rigid foam insulation panels add an R value of 5 per in. thickness of the panel
    • Specifications
      Product Depth (in.) :
      2.15
      Product Height (in.) :
      24
      Product Width (in.) :
      48
      Returnable :
      90-Day
    • Reviews
      (1)

      Ratings & Reviews

      100% of customers recommend this product
      5.0
      Out of 5:
      5
      [1]
      4
      3
      2
      1
      QUALITY:
      VALUE:
      4.0
      4.0
      • Styro FP Ultra Lite 2"x2'x4' Panels
      • December 12, 2014
      • Recommended Product

      I live in Massachusetts and heat with oil. I'm an energy engineer. I had about two feet of exposed foundation around the majority of the perimeter. Not only was the basement cold, but I had a lot of significant duct and pipe losses through the space. On an extremely cold evening, an IR gun shot at the interior of the above ground would indicate a below freezing temperature on the interior. Green Building Advisor equates six inches thick of a typical bare foundation equal to a R factor of 1, or about equal to a single pane window. Imagine a window two feet high around the perimeter of the basement and you get the picture. GBA also prefers exterior foundation as it brings the foundation into the conditioned space rather than the interface. They claim that this increases the thermal mass of the house and a will result in a corresponding reduction in fluctuations. I'm a believer now. I wanted a foundation insulation system that was 1) aesthetically pleasing, 2) durable 3) easy to install 4) reasonably cost. You can buy the pink insulation boards easy enough but a UV resistant and durable surface becomes an issue. Thought about cement board as an exterior, looked into the trowel on coatings ,and chose to go with the FP Ultralite one step solution instead. Packaging for the product was very well done. Expect to get some spalling of the aggregate on handling so minimize where possible. The product does not cut as cleanly as they claim and mitering corners takes some practice and patience. Invariably you will chip off aggregate in unwanted places and HD does not offer the Styro aggregate as a stand alone offering. An email to Styro will set you on a trail to another distributor. A little hokey for trying to get a couple handfuls of aggregate (colored sand). One other beef is that HD doesn't off the J channels to protect and hide the lip at the top of the panels. I'm trying to figure out a drip edge to serve the purpose. The only other advice I'd offer is to utilize Loctite PL300 and forego drilling the panels. Chipping and pull-through-patch-up will be needed otherwise. Overall I strongly recommend the panels and are very pleased with the purchase. I intend to advise my clients to investigate this product as well.

      Pros Performs Well, Easy to Install, Stylish, Great Value
      • Pro

      Patriot

      Western Massachusetts
      45 to 54, Male
      more details...
      By: Patriot
    • Shipping & Delivery Options

      Shipping options for [zipcode] (change)

      Arrival dates and shipping costs shown above are estimates.See exact dates and costs and select your preferred shipping option during checkout.


      EXPRESS DELIVERY FROM STORE:

      Express Delivery from Store is available for items currently in stock at a The Home Depot store within a delivery ZIP code. A driver from a local store will deliver the item(s).


      Outside Delivery:  Service includes delivery to area outside the house which is accessible by delivery equipment.


      Threshold Delivery: Service includes delivery across your first doorway or threshold (ie. garage, backyard, deck, first room of the home).


    This item cannot be shipped to the following state(s): AK,GU,HI,PR,VI

    Find More Foundation Plates, Panels & Vents TAP TO FILTER