300 ml. Translucent PC-SuperEpoxy Adhesive Paste Cartridge

Used it to install and firmly set iron balusters in a stairway. Was a clean install without any drip. Once fully cured the balusters are immovable. Highly recommend this product

Worked great when installing iron balusters. Now I've found that I use it quite a bit on other projects. Ten times better than the mess of using construction adhesive. Stuff comes out the consistency of Vaseline - so it holds it's form and does not sag. Can be very precise dispensing thru the small hole in the mixing tube. The cartridge is also reusable.......just need to take off the long mixing tube and put the little cap back on the cartridge. Just be aware that the mixing tube needs replaced every time - as the mixed epoxy hardens inside. Also be aware that the epoxy dries white. PC Products has another version of this cartridge that dries clear - but I have not used it yet. Some people have given the cartridge a bad rating since you need to buy the separate gun to dispense the epoxy.......all they need to do is read the product description where is says you need the gun!

Easy to work, paste texture stays in place while drying. I would prefer "clear" when dry, but the translucent was fine as expected. I mixed some fine strained teak saw dust in with the product and attained a suitable small patch on the repair I did. I would purchase this product again.

This works great. Wish it stayed flexible just a little longer.than 15 minutes.

Rating provided by a verified purchaser

This product worked extremely well for setting iron bollards in red oak wood. I particularly liked the consistency of the product, which kept it in place while working under the hand rail.

It locks in place and is fast drying. I love that it stays put and does not run while doing projects.

Rating provided by a verified purchaser

I had some concerns about using epoxy as I read some reviews where people had bad experience with it but in my case this product was great. It comes out as some sort of paste so it doesn't drip and once you wait the 3-4 hours as indicated in the instructions those balusters will stay in place forever. My recommendation is to go slow and do one baluster at a time. You don't need to put a lot of the epoxy per baluster and by doing so you should be able to use one cartridge for 15-20 balusters.